Cat Pumps泵的维修销售表下载

  Pump Manifold or Fluid-End

Pressure Regulating Unloader Valve - Used to set and maintain consistent system pressure. Rotate clockwise to increase pressure or counterclockwise to decrease pressure.

Pump Inlet Port/Garden Hose Fitting

Chemical Injector

Inlet Auxillery Port - Used for additional accessories such as an inlet filter or thermal valve.

Drain Plug - Drain plug and oil filler cap can be switched to mount the pump 180 degrees.

Oil Sight Gauge - Oil level should be in the middle of the sight gauge when the pump is not in operation. 

Oil Filler Cap

Pump Drive-End/Crankcase

Pop-Off/Relief Valve - Used for secondary protection against over-pressurization.

Thermal Valve - Used on closed loop by-pass lines to recycle water in event of excessive heat.

Pressure Gauge - Used to accuratley monitor pump pressure.

Inlet Filter - Used to capture and prevent contamination particles from entering and possibly causing damage to the pump and system components.

By-Pass Hose - Used to route pump flow from unloader back to pump inlet when system is running in bypass.